Mikro-just bits??

[MarkM]

I have to re-install my mikro-just into a new plate.

Are these the correct bits?

 

Counter sink: 3/8 82 degree

Drill bit: 1/8

 

 

[Horton]

looks right

[MarkM]

Thanks man. Did you confirm the numbers with one that you have? Just want to be certain before I mangle a new plate.

[Horton]

No it looks right but I did not actually check

[MarkM]

Ok. Just verified that those are the ones. Thanks!

[skialex]

They look right, but you can compare the screw with the drill bit and the size of the screw head with the width of the countersunk bit, don't even need a caliper for this. If they are about the same nothing will go wrong and it is not rocket science. If by chance you make a mistake you can always drill at the other side of the slot or the other side of the plate, you have 4 tries or more if it's a hardshell plate.

B)

[skialex]

I went to my garage and took a picture of some mikrojust hardware because I couldn't read the letters on the face of the bits. Yes they are right.