DSC 5433

The Connelly GT-R is the only current high-end ski that has been continuously evolved for more than a decade. The GT-R is the direct descendant of the Connelly F1 that was Jamie Beauchesne’s masterpiece more than 15 years ago. Since then the design has been gradually improved with multiple materials upgrades as well as tweaks to the tunnel and sidewall profile. Through it all the ski maintains the original DNA.

General Feel

In all aspects discussed below the GT-R works best when the skier does less. The ski does not want you to lean and pull harder than needed. The ski wants you to tell it when to turn but not push it to turn. The ski wants you to stand in the middle of it and let it do the work.

In many ways, the GT-R requires less technical skills than other top of the line skis and it is less likely to punish the skier for small mistakes.

Is it a fast ski or a slow ski? That depends on how you set the fin and bindings. My preferred settings for the GT-R resulted in a ski that is not crazy fast but was not a lot of work and consistently cast out wide of the ball.

DSC 5303

Off Side Turns

Skiers with understated upper body moments and centered weight distribution will find the Off Side turns to be reliable and stable. The tip of the GT-R pulls to the inside of the radius aggressively without a feeling that tail of the ski is sliding. It is more of a carving than a sliding turn. The result is a very secure turn ending with lots of angle.

On Side

If the skier is centered on the ski from the wakes to the ball On Side turns are absolutely dependable. The ski flows out and then carves a tight turn at the ball.

If the skier lets their weight distribution move back or attempts to force the On Side turn by pushing on the tail the ski is likely to carve a slow turn. When this happens the GT-R will not turn sharp but it will maintain enough water speed to allow the skier to recover from his / her error.

DSC 5308

Ball to the wakes

From the ball to the wakes the skier’s weight distribution is again critical. With an adequate stacked position, the skier will achieve ample speed with minimal effort.

Wakes to the ball

The GT-R is loose in terms of roll stability. What this means is that if a skier moves to the inside early or too quickly after edge change they will find themselves leaned in more than expected approaching the ball. Correcting for this does not mean a monumental change in technique but may require a few rides to adjust. (Just keep your shoulders level and chin up).

Older skis from the F1 lineage required the skier to maintain as much line tension as possible from the second wake to the ball in order to achieve width. That is no longer the case with the GT-R. It is recommended that you have as much line tension as possible but your width at the ball does not heavily depend on it.

DSC 5275


During the review, I did not do extensive experimentation with settings because the settings Martin Bartalsky provided worked so well. The GT-R can be set up a number of ways but settings on this ski can be finicky. 

My final settings for the 67" GT-R 29 3/8 - 2.478 - 6.910 - .772 

At 183 +/- lbs I rode both the 67” and 68” GT-R. Most of the rides for this review were on the 67” but I ran into 39 off in practice on both skis. If I started the review over I would likely start with the 68”. I consider the GT-R to be slightly small for its advertised size.


There are review skis I am happy to get my bindings off of and there are skis that I would like to ski more on. The Connelly GT-R is a ski that I would like to keep skiing on. If your style is calm and centered the GT-R is a ski you must try.

You are using an ad blocker?!?!?! BallOfSpray relies on revenue from advertisements so please consider disabling your ad blocker for this domain.