jimski

Thanks Richard 

Does any one have a source for these pig tails.

2011 pcm 5.7

goes to the coil

two wire rectangle style pin 

thanks 

Wait until the bugs start sticking to them.

Maybe it’s just me, but watching Freddie ski in tournaments brings the excitement that keeps me wanting more.

great skiing today.

Probably won’t even watch the master now.

no Freddie = no fun 

@RichardDoane@RichardDoanewhen we need a re power we will defiantly be bringing it down to you 

@RichardDoane you nailed it.

new coil module vroom vroom 

thanks for every one’s input 

Double check the muffler.

I had mine leaking on the bottom of it, very hard to see unless you pull the floor board off.

I put a new potentiometer in May be two or three years ago and updated the ecm

Thanks @Jody_Sealand @RichardDoane

i checked everything I could think of.

replaced the CPS with one I had.

completely  gone over the distributor .

have 12 v every where there should be going into the coil and the module.

5 volts at the CPS and into the distributor. But no spark out of the coil.

just waiting on the coil and module from wizard lake marine.

I do have a tiny bit of corrosion under the coil module.

if you weren’t looking carefully you’d pass right over it.

Got ya 

thanks 

58 psi fuel pressure. How do you know if the low pressure fuel pump is working.

checked about everything I can.off to the shop I guess 

thanks everyone 

What do you mean by that @Jody_Seal

Thanks guys 

I did hard wire the kill switch.

have been swapping around relays and  checking for power. I will put the fuel pressure gauge on next .
I did find another relay under the dash. I will look into this a little more.

Thanks @jpwhit Yes I did the cap and rotor this year. It still should have spark out of the coil.

I checked the plug going into the coil an no power at it. 

Seem to have power every where I check fuse box, relays, both d fuel pumps.

still no spark out of the coil.

might pick up a new coil tomorrow and try it.

Power relay code on here now 

If it’s a bad relay or wiring harness issue would the coil quit sending spark 

Only one fuel pump relay

@RichardDoaneno spark to the plugs 

this engine has no circuit breakers on the back of the motor 

Thanks Richard 

2011 200 won’t start cranks overbuy won’t fire.

replaced fuel filter and fuel control cell filter. Checked fuel control cell wires and can’t find any thing no fuses popped.and comes up with this code.

any ideas 

thanks 

I put a patch on it but I’m worried it will continue to crack with vibration.

It’s just over 1400$ CAD to have a new one shipped to me.

Starting to crack @Jody_Seal