Baller slalomboy96 Posted October 10, 2012 Baller Share Posted October 10, 2012 Hi guys, putting ZO into my 08 response, does any one have any photos of the install process, if having trouble finding the twin master slave cylinder connector. Link to comment Share on other sites More sharing options...
Baller Doug Posted October 10, 2012 Baller Share Posted October 10, 2012 Did you get the plug and play harness peace from Malibu it makes it about a 45min job most of that is drilling and running antenna wires Link to comment Share on other sites More sharing options...
Baller slalomboy96 Posted October 10, 2012 Author Baller Share Posted October 10, 2012 Yeh, I got the extra canbus wire kits, all female plugs? Just doesn't make sense Link to comment Share on other sites More sharing options...
Baller_ Jody_Seal Posted October 10, 2012 Baller_ Share Posted October 10, 2012 Their may not be a twin connector in the indmar harness for the malibu . However their are only two wires you need to "T" into for ZO digital engine information. That is can high and can low in the round multi pin connector that connects the engine to the boat harness's. I prefer to to utilize this method over the twin connector because I have seen that part of the circuit be non functioning. We can get you the pin out numbers to identify which two wire's in the plug you will need. in the PCM harness i believe it is 17 and18 none the less we can identify for you later this morning. Link to comment Share on other sites More sharing options...
Baller slalomboy96 Posted October 10, 2012 Author Baller Share Posted October 10, 2012 @jody seal thanks any help would be greatly appreciated, any chance of a photo? Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now