Radar Strada binding setup on Syndicate Omni.

[nam1975]

Does this need to be adjusted at all from the 29.5” on HO website?

I seem to remember a slight adjustment when I put this binding on my D3?

 

Thanks for any input!

[BraceMaker]

Of all the numbers I find the binding initial measurement to be the least useful.

 

If you consider set up of several different bindings, say your Radar, a Reflex, a Wiley's, where your ankle sits in relationship to the heel of the boot can be significantly different, even the different liners you can buy for hardshells change them quite a lot.

 

I would probably start by measuring your current binding on the D3, if you find that you are 1/4" forwards of recommended numbers I would probably start there and try moving a bit closer to the factory number set after set.

[Ski_Dad]

i have an HO ski and when I set my Radar Vector (Alum Plate) in the middle hole it was right with the recomenmdation for my ski - and it feels right. Did the same thing for my boys CX ski

[Chef23]

Easier from the stitching on the back of the bottom of the Strada.

[ALPJr]

I have double Vapor boots and a Sequence plate on a HO. Got them right where I want them.