I now have sets of CG Denali wider gauges as well as the regular and I have low angle regular now as well.
As @BuoyChaser mentioned you can just use a shim to use your regular gauges with the CG wing instead of the special CG set, but the first person that asked me about the CG fin set tried that and just found it easier to have the wider set and not mess around with a shim. Thus the creation of the wider set. But the wider set costs more to make and mail (they don't fit in a COM10 letter sized envelope like the regular set, they weigh more than 30g, they use more material, and a set of 6 takes at least 3 hours on a 3D printer to make) so I am charging $10 for a set of 6. Regular ones can work with regular alone or with CG Denali fins with a shim. Wider CG Denali ones work only with CG Denali fins. Your choice. (regular set of 6 takes 2 hours to print BTW... so I am not getting rich on any of these)
@BraceMaker has a good suggestion but again, adding shims of any form does complicate things and when trying to set angles within 1/2 degree, any time you add complexity you reduce repeat-ability and accuracy so I think I will take a pass on the angled shim approach.
So for each type I have 3 sets...
3 different sets of regular width at $5 per set
Low Angle: 4.0,4.5,5.0,5.5,6.0,6.5
Standard Angle: 7.0,7.5,8.0,8.5,9.0,9.5
High angle: 10.0,10.5,11.0,11.5,12.0,12.5
3 different sets of wide CG Denali Wide at $10 per set
Low Angle: 4.0,4.5,5.0,5.5,6.0,6.5
Standard Angle: 7.0,7.5,8.0,8.5,9.0,9.5
High angle: 10.0,10.5,11.0,11.5,12.0,12.5
All listed on SIA in the miscelaneous section and all also available on Thingiverse for free if anyone wants to print their own.
I have also changed the regular set just now to have the bottom cut out like the CG Denali set (again at the request of the first person to ask about wider ones for the Denali fin) so that they sit flat on a curved ski base to get more repeatable results.