jim parr

Alex: I had this problem. It was the CR/CS setting. I have a 6.0 liter engine. Perfect Pass told me not to go too low with this setting. Low being 1600. I am at 1530-- problem solved. To access this press menu and up at the same time.Press down key to get to control settings. I think you will find the CR/CS value there.

TW:PCM is a great company and will stand behind their engines. This is likely a cam retard issue. Contact your dealer. There is possiblly a service bulliten about this.

I figured out why the math doesn't add up when measuring from the front of the fin to the back of the ski.Its because the caliper has two sets of tips, one set the tips are on the outside of the object being measured, the other set measures from the inside out.When taking that measurment one tip from each set is used.I know this is confusing , but its the best way I can explain it.

TW: I agree the math does not add up as it should. I measure from the front of the fin to the back because its a more reliable measurment. You can place the caliper on the fin and push it against the ski. Very repeatable.The way I measure DFT is to put the small end of the caliper against the ski and slide the pin towards the fin.Very unreliable. Â I don't know why it doesn't add up. Any ideas out there?

Oh the wing is@ 9 degrees.

I really like this ski. I have made more fin adj. to reduce excess movement such as tip rise on on-side. I wonder what REGINA J's fin settings are? I am 34 MPH skier-155lbs.. I am on 66 strada. Strada bindings, seq. plate -one notch back from center.DFT.734, L 6.808,D 2.504, Front of fin to back of ski 8.195.

I purchased a 66 strada july 9th. I was struggling @ stock settings. Yesterday I set fin @ ShaneH's fin settings. Today I ran 38. I think anyone on this ski should not overlook this setup.