skiray Posted October 13, 2014 Share Posted October 13, 2014 A five gallon can turned over in my truck and poured a couple of gallons out on my daughters jacket. Any way to get it out or do I just order another one? I've never seen that type of can turn over before. Got two ski socks and a life jacket. Make sure you do a better job tieng your up. Link to comment Share on other sites More sharing options...
Baller Chuck_Dickey Posted October 13, 2014 Baller Share Posted October 13, 2014 Soak it in a tube with Dawn dish washing detergent. That's what they use to clean up crud oil of birds. It may take more effort than it's worth but it will work. Link to comment Share on other sites More sharing options...
Baller thager Posted October 13, 2014 Baller Share Posted October 13, 2014 Pull its finger then wring it out and "Ditto" what Chuck_Dickey said. Link to comment Share on other sites More sharing options...
nzcabbage Posted October 13, 2014 Share Posted October 13, 2014 Get some Simple Green. It will break down the fuel and wash out in water Link to comment Share on other sites More sharing options...
Baller Intheday Posted October 13, 2014 Baller Share Posted October 13, 2014 Soak as above then Toss it through a front loader washing machine on gentle cycle Link to comment Share on other sites More sharing options...
Moggie Posted October 13, 2014 Share Posted October 13, 2014 Light it...when the fire goes out there's no more gas. :) Link to comment Share on other sites More sharing options...
Baller fu_man Posted October 13, 2014 Baller Share Posted October 13, 2014 @Intheday I wouldn't put it in the washing mashine. Would be concerned about it stinking like gas afterwards when the wife goes to put in a load of whites. I think my washer had a warning about not washing stuff soiled in gas/oil/solvents when I installed it. Link to comment Share on other sites More sharing options...
Baller Intheday Posted October 13, 2014 Baller Share Posted October 13, 2014 @fu_man got to admit our jackets and wetsuits haven't been around in our front loader but at the end of the season the go around at the laundromat front loader Link to comment Share on other sites More sharing options...
Baller A_B Posted October 13, 2014 Baller Share Posted October 13, 2014 At the end of the season I always put jackets and Neo tops, etc., in our slop sink filled with warm water with Tide added in. You sort of have to push down on the jacket all,over repeatedly to get it to suck in the water, then I fill with cool water only and rinse it out the same way until no more soap comes out. Usually takes a couple rounds to get all the soap out. It's amazing how dirty the water is. You might be able to do a few rounds of soap like this and throw some lemon in. Link to comment Share on other sites More sharing options...
boarditup Posted October 14, 2014 Share Posted October 14, 2014 Neoprene is degraded by contact with gasoline. You may be able to ressurect it by the cleaning methods above, but do not be suprised if there is permanent damage. Link to comment Share on other sites More sharing options...
Baller eleeski Posted October 14, 2014 Baller Share Posted October 14, 2014 Aren't fuel lines neoprene? Of course there are other foam flotation fillers so @boarditup is right - inspect the vest carefully as the insides may have been damaged while the outside looks fine. Of course, I removed the foam filler on a vest for some crazy experiment. I still have the vest, it floats a bit, protects a bit and sort of fools the harbor patrol. Not as safe but sometimes useful. Bring your gas soaked vest to our hot dry desert. It will bake out. Hopefully it won't spontaneously combust - and you won't either. Eric Link to comment Share on other sites More sharing options...
boarditup Posted October 14, 2014 Share Posted October 14, 2014 Fuel lines are typlically nitrile rubber - a few other synthetic compounds are also used. Some of the older hoses did have a neoprene covering over the reinforcing, but I don't think you can find those anymore - nothing with a USCG stamp, anyway. Look at the recommendations for protective gloves - neoprene is not rated for any gasoline contact. Both gasoline and alchohol are hard on neoprene. Link to comment Share on other sites More sharing options...
Baller Texas6 Posted October 15, 2014 Baller Share Posted October 15, 2014 If you soak your gloves in fuel you'll quickly forget about the jacket - problem solved Link to comment Share on other sites More sharing options...
Baller Stevie Boy Posted October 15, 2014 Baller Share Posted October 15, 2014 My point of view is, if you do not want to see your daughter go up in flames , order a new one ! Link to comment Share on other sites More sharing options...
Baller A_B Posted October 15, 2014 Baller Share Posted October 15, 2014 you could get some Citrus cleaner and add to the Tide or laundry detergent, then soak in slop sink and then agitate the heck out of it. Aside from that, I would be at a loss if I did that a few times and still stunk. Let it hang outside to air out, and if it still smelled, sell it on SIA. (jk)! Link to comment Share on other sites More sharing options...
Baller LeonL Posted October 16, 2014 Baller Share Posted October 16, 2014 Dawn is the best product to use to dilute petroleum. Removing smell however may be difficult. Give a a good soak and wash with lots of Dawn, rinse well and air out for a few days. Link to comment Share on other sites More sharing options...
Baller mwetskier Posted October 16, 2014 Baller Share Posted October 16, 2014 best fix for a gasoline soaked ski vest is to hang it outside for several days until the volatile compounds have evaporated then wrap tightly in plastic and store it in a dumpster for the rest of your life. Link to comment Share on other sites More sharing options...
Baller ToddL Posted April 22, 2015 Baller Share Posted April 22, 2015 Crud! This just happened to me, yesterday. Thankfully, my car's trunk had a rubber liner which kept the carpet protected. Unfortunately, my Eagle vest soaked up about a pint of gas. I rinsed it out as much as possible on site. When I got home, I filled a plastic storage tub with water and Simple Green cleaner and worked it for about 30 minutes, replacing the water a couple of times. Then, I let it soak overnight. We'll see... Other steps to try will include: Coating in Baking Soda to soak up oils Washing/Soaking in Vinegar and Water More Baking Soda... Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now