More your bindings less than 1/10th inch? Mikro-Just

[Horton]

 

[Horton]

http://www.mikro-just.com/

[The_MS]

Getting my new Vapor set up right now.

[thager]

@MS Did @OTF leave mine at your place yet? Weather is finally warm here but blowing like a banshee!!!

[The_MS]

I have your boot but it is not ready yet. You can ski with it until he is ready to install it.

[OTF]

@horton you're still running the demo unit! Thats 3 yrs old now........do you ever use it? Looks new

[OTF]

@thager I can do it Friday AM along with @ms second one.

[jetpilotg4]

Question for you guys with the mikro-just how far off of the factory binding placements do you eventually end up , or maybe your off of your pre mikro-just locations ?

[Horton]

@jetpilotg4 it's different for every ski and binding combination. The point of Mikro-just is to be able to adjust the smallest amount possible. The old school standard minimum adjustment is 3/8 of an inch. When fine-tuning a ski that is gigantic

[eleeski]

Hmmm, my ankle has a lot of slop in the joint. Micro adjustments are lost by the play in my ankle. I do move my bindings - a lot from factory. If I micro adjusted them it would take me all summer to find a good setting.

 

Eric

[Horton]

@eleeski do your skis have a factory setting?

[mbabiash]

my mikro just has been on my sequence plate for almost two years now.

I tried to take the Allen screw off yesterday because I need to lengthen the slot a bit more. I couldn't get the screw off. It won't budge. Any ideas. I don't want to break it. I can't remember if it had loctite or not and I'm wondering if the two metals are not happy with each other.

Thanks matt

[MattP]

@mbabiash I have not had any issue. Have you tried some PB Blaster?

[mbabiash]

PB blaster? What's that?

[MattP]

@mbabiash PB Blaster