Intuition Aqua Liners - custom molding

[cruznski]

Hello! Well it is warming up nicely and skiing more days a week here in NorCal. I am about 1 yr in on my white cuff reflex and XL Intuition liner on front and am very pleased with it. Now I just used the Aqua liner out of the box and the set up is the best I have ever had. What I am experiencing is FOMO (Fear of Missing Out) has anyone run it as is then molded it and if so what was the degree of improvement experienced? I am pretty sure there's some wisdom out there on this.

[C5Quest]

Will only get better when you mold it.

[BraceMaker]

Depends a bit on your liner and foot but I've never had one feel worse after molding it.

[Lovell]

I am using the reflex white cuff with the thin reflex liner— been happy with it. Which intuition are you using?

[cruznski]

Intuition Aqua liner.

[PatM]

Mold it

[h2oskibadger]

I just got an intuition liner, size L (10-11) for size 10 Reflex Supershell 6.0. My foot measures just over 11" so it's on the upper end of the size 10 shell. The liner seems like it has a lot of room, however. And when I put it on and in the shell, I can just barely get 1 notch on the lower 2 buckles because it seems like there's so much liner material around the foot. Does the liner shrink when heated up for molding or is it better to have a smaller size liner that you can stretch out when molding?

[BraceMaker]

The liners will shrink when you heat them but stretch when hot. Basically if too loose if you warm it up it will shrink. But if you add a few spare socks into a hot liner it will mold looser.

[oldjeep]

Intuition liners pack out when you mold them. I run them in my race boots and they always start out way too tight.