Jdubs Posted June 15, 2015 Share Posted June 15, 2015 I know that some people are going to think this sounds hair-brained crazy, but trust me and try this. If you are consistent with this method I am going to tell you about, chances are you will never need to tape your blistered hands again. Keep your razor in the shower and when your are about done showering and your skin is soft or pruney, run the razor over the callused spots. Yes - Shave off the thick skin that normally tears on your hands. Typically its the calluses from skiing or working out that will thicken up and cause skier blistered up or torn hands, especially when the water warms up. Yes, you read it right... Shave off your calluses consistently and you will not likely need tape, neoprene power-pulls, or glove underwear any longer. However, if you forget and do tear your hands open, use superglue if there is a flap of skin to glue back to your hands. It's basically the same ingredients that dentists use to substitute for bandaging and superglue stings far less than liquid bandage. Good luck. Link to comment Share on other sites More sharing options...
Administrators Horton Posted June 15, 2015 Administrators Share Posted June 15, 2015 MasterLine Masters Curves gloves are my magic hand saver Goode ★ HO Syndicate ★ KD Skis ★ MasterCraft ★ PerfSki Radar ★ Reflex ★ S Lines ★ Stokes ★ Baller Video Coaching System Drop a dime in the can Link to comment Share on other sites More sharing options...
Baller aupatking Posted June 15, 2015 Baller Share Posted June 15, 2015 Worth a try. I've done the super glue routine and don't enjoy it as much as you might think. Thanks for the info @Jdubs Link to comment Share on other sites More sharing options...
Baller_ The_MS Posted June 15, 2015 Baller_ Share Posted June 15, 2015 I have some large Master Curves for sale if someone wants a killer deal on a 1 set used pair. Link to comment Share on other sites More sharing options...
Baller Waternut Posted June 15, 2015 Baller Share Posted June 15, 2015 What about the people who develop blisters before the end of the day? I've tried shaving, sanding, filing, taping, new-skin bandage, palm protectors, kevlar liners, regular gloves, kevlar/leather gloves, round handles, elliptical handles, and V shaped handles. Some combinations works better than others but 3 sets is out of the question without taping. When it's really warm, 2 long sets is just about out of the question without taping. I've spent well over $1000 in handles and gloves and I'm still looking for something that will help. Most of my trials just move the blisters from one place to another. I usually do the first set with gloves and palm protectors. If I'm feeling like a 3rd set that day or I'm already starting to see signs of blisters, tape or glue is the only real option. Link to comment Share on other sites More sharing options...
Baller 6balls Posted June 15, 2015 Baller Share Posted June 15, 2015 clincher/pro-lock/vice style gloves are a huge hand saver as well. Link to comment Share on other sites More sharing options...
Baller Fatroll Posted June 15, 2015 Baller Share Posted June 15, 2015 I use a veterinary orthopedic bone rasp as a file and use surgical glue for repair of any skin flaps. This is a job perk I never expected when I entered veterinary medicine Link to comment Share on other sites More sharing options...
Baller Lieutenant Dan Posted June 15, 2015 Baller Share Posted June 15, 2015 Master Curves with neoprene hand savers underneath....but the magic formula (for me) is to use as small of a handle diameter as you can....forces you to hold the handle out in your fingers more and not bunched up in your palm....for me that's how I always broke free the calluses Link to comment Share on other sites More sharing options...
Baller Steven_Haines Posted June 15, 2015 Baller Share Posted June 15, 2015 @Waternut, How Tight are your gloves? Maybe they're moving around causing the problem. Link to comment Share on other sites More sharing options...
Baller Waternut Posted June 15, 2015 Baller Share Posted June 15, 2015 My gloves are extremely tight. I have to let them soak for a minute or two before I can even think about getting them on. I'm actually tearing up the outside of the fingers from getting them off. I'm using medium Radar BOA's. Have tried using small's and I can get them on but it requires excessive strength to grip the handle with them that small and my grip strength goes out prematurely. Last year I struggled with calluses on my palms and the palm protectors helped a lot. This year using the same handle and gloves, I'm getting blisters on the bottom of my fingers. I've always been a bit of a finger gripper but I may have to learn to grip the handle deeper to prevent problems this year. Link to comment Share on other sites More sharing options...
Baller Stevie Boy Posted June 15, 2015 Baller Share Posted June 15, 2015 I know people who have changed the Size/Diameter of their handle and seem to suffer less, do you think handle diameter for different size hands makes a difference ? Link to comment Share on other sites More sharing options...
Baller skinonstop Posted June 15, 2015 Baller Share Posted June 15, 2015 Dry gloves and dry glove underwear change with each set and never have blisters anymore. Link to comment Share on other sites More sharing options...
Baller_ The_MS Posted June 15, 2015 Baller_ Share Posted June 15, 2015 Ski up north and you wont have any problems. Link to comment Share on other sites More sharing options...
Baller thager Posted June 16, 2015 Baller Share Posted June 16, 2015 Handle size made a difference for me. I callus badly using smaller diameter handles. I went to a 1.10 inch size and have not ripped any in quite a while. Link to comment Share on other sites More sharing options...
Baller nam1975 Posted June 16, 2015 Baller Share Posted June 16, 2015 Pay attention to your palms and grip on your pull up, change it ever so slightly each up. My hands take more abuse from getting up, than the skiing. Link to comment Share on other sites More sharing options...
Baller Ed_Obermeier Posted June 16, 2015 Baller Share Posted June 16, 2015 Clincher/pro-lock/vice style gloves with Overton's palm pads underneath, I hardly even get a callus much less blisters. But (unfortunately) I don't get to ski as much as most here either. Link to comment Share on other sites More sharing options...
Baller gt2003 Posted June 16, 2015 Baller Share Posted June 16, 2015 Agree with @nam1975 , On each pull up I could feel the handle slide across my calloused area just a bit before I got out of the water. I don't think the actual skiing did too much damage. Link to comment Share on other sites More sharing options...
Baller skialex Posted June 16, 2015 Baller Share Posted June 16, 2015 Very tight gloves, no carbon palms though! I also use sand paper if needed and sometimes my Dremel with sand paper bit at slow revs. I haven't done any sanding this season yet, I ski 5sets a week and need 2 pair of gloves per year. I think it's very important to have a tight fit and change the gloves when needed even if visually they look ok! Link to comment Share on other sites More sharing options...
Baller Nando Posted June 16, 2015 Baller Share Posted June 16, 2015 No blades! Use a pumice stone or sandpaper (or a low speed Dremel- I know a dentist who uses dental buffers- went in for a cleaning once and there he was grinding away on his hands), but blades leave edges that can make things worse. Sand 'em down every day to keep from tearing. Plus, MS is right- the northern water doesn't soften callouses nearly as much- maybe just because the water is so much colder we get out and dry off quicker. Link to comment Share on other sites More sharing options...
Baller Texas6 Posted June 16, 2015 Baller Share Posted June 16, 2015 a low speed sounds like a hole in my hand waiting to happen Link to comment Share on other sites More sharing options...
Baller Nando Posted June 16, 2015 Baller Share Posted June 16, 2015 Well, I wouldn't use a dremel tool- or any other power tool... Link to comment Share on other sites More sharing options...
Baller ski6jones Posted June 17, 2015 Baller Share Posted June 17, 2015 I've use a single edged razor blade for years with good results. Just need to be VERY careful. Wet pruney hands first is the best approach. Flame away! Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now