Can someone measure a Vapor binding for me.

[gregy]

I'm trying to dial in my blue Vapor. Radar measures from the lower stitches on the Radar boot. Can someone, maybe use a square and measure the difference between the rear most point of the boot and the stitches. I've been assuming about a 1/4 of an inch.

[gregy]

@Chris Rossi or @eddie_roberts_jr any info on this would be much appreciated.

[Chef23]

It may be tough to get one of the Radar guys to respond given that they are all at Nationals. I don't have a Vapor but a Strada boot. I am not sure that it is 1/4" I think it is less. If you want me to check I will let me know.

[gregy]

@chef23 thanks, if you can see what it looks like.

 

On a 67" blue Vapor. I think I have been to far forward. Might have gone back too much now. The water is heating up lately and I've been killing myself to get wide. One set with the bindings back on Monday and I was effortlessly wide but I felt slightly unstable. I'm now using T-factors, as soon as I fell like the settings are where I want the them I have a OB4 setup waiting to go on.

[Chef23]

@gregy I will do it tomorrow for you.

[Bill22]

 

[Bill22]

@gregy I need 3 hands to get a good measurement. 2014 Vapor boot top thread is a little less than 1/8". Bottom thread about 3/16". Hope this helps.

[Chef23]

I was just going to my shed but looks like you got what you needed.