Boot spacing help - Radar Carbon sequence plate vs standard plate

[C5Quest]

So I’m experimenting with boot options and came across a deal on some new Vapor boots a while back. They came with the individual plates like they normally do but wanted to give the Radar sequence plate a shot for quickly swapping skis. I picked up the new carbon model and found the closest I can get the boots (heel to toe) is about 1/4 inch or so. I usually run boots/binding as closest possible. I can get them touching heel to toe with the indivual plates but not the carbon sequence plate. Anyone have the standand (non carbon) radar sequence plate and have the same issue? Wondering if this is only a carbon plate issue or same on standard sequence plate as well. Running a size 10 Vapor boot. Only one mount option on the front. Rear has multiple holes to accommodate spacing but no luck getting them where I want/need them. Give it a shot and swap out for the individual plates if I find the gap too big. I’m on the shorter side so spacing is big deal for me.

[davehr40]

Same set up, boot size and issue as yours, I just squished the toe of the rear binding into the heal of the forward binding, did not impact feel inside either boot..

[mikegile]

Agree with @davehr40. I have size 10's and can get the back boot pressuring the front. I recently moved it to the next hole back and like it a bit better.