Nautique 200 spacing for boat lift bunk spacing

[Rivvy]

Can someone help save me some time by suggesting bunk spacing for boat lift?

[countymountie]

The beam is 95". Are you talking about the bunks that are underneath the boat? I just measured mine out so they are close to the bunks on my trailer.

 

[bigskieridaho]

+1 for trailer bunk spacing

[Rivvy]

Thanks. I think I will start with the stringers on both sides of the engine dimension first. If I start with the wide trailer bunk dimension, I'm afraid the keel will hit cross member in front. I would need to redue how the bunks are supported to use wide trailer bunk spacing. Plus I'm in a shallow water situation. I've got a vibo 3600# cantilever lift with rear cutout.

[ColeGiacopuzzi]

@charlieskiwest When you move your trailer bunks here's your answer on spacing.

[DavidN]

I was just about to ask the same question then found this thread.

I have a vertical 4500lbs lift with 2 bunks, currently adjusted to fit a Malibu Response.

I need to adjust the bunks to fit a Nautique 200.

Can anyone provide me with some measurements. Please.

Thanks in advance!

Here’s the setup:

 

[jayski]

From my TXI to my new 200 I just narrowed the front of the bunks so there is about 24" ish in between

[Ed_Johnson]

I also went from a Malibu to a 200 in 2011. Just measured the trailer bunks and matched them, then checked them from underneath with the 200 on them. Worked perfectly.

 

 

[DavidN]

@Ed_Johnson

I really wish I could do that!

Will pick up the boat next month and would love to have the lift set up by then.

Still no sufficient data. And unfortunately no (more) 200’s on our lake to measure.