Jump to content

Mastercrafter

Baller
 View Profile  See their activity

  • Posts

    870

  • Joined

  • Last visited

  • Days Won

    6

 Content Type 

Everything posted by Mastercrafter

  1. Mastercrafter
    Ouch, Sledge.
  2. Mastercrafter
    @lefty.. where are you located?
  3. Mastercrafter
    Unfortunately they’re not cheap. Great Lakes Skipper had some NOS screens on eBay for $3400 a while back but now this is the cheapest at $4300. Dealer is closer to $4800 I believe. https://www.ebay.com/itm/404415479384?mkcid=16&mkevt=1&mkrid=711-127632-2357-0&ssspo=PPsq0eSBQmO&sssrc=4429486&ssuid=a-9NW19sQAi&var=&widget_ver=artemis&media=COPY a dealer
  4. Mastercrafter
    I’d say run it. Skied a 2014 a handful of times this winter and it has the same high-pitch whine in gear at idle. I picked up a 2014 recently and it has a bit more whine than the boats with the updated trans, but not as bad as some. My neighbors 2001 Response sounds the same, coincidently. All the noises go away under load leading me to believe its some loosely meshed gears. Spinning your driveshaft while dry can be noisy especially if you have the rubber strut bushing versus a PTFE like OJ sells.
  5. Mastercrafter
    Ski it a set. Mine felt fine after a couple passes.
  6. Mastercrafter
    Looking for a trailer for a late model Prostar. The closer to Michigan the better, but willing to travel.
  7. Mastercrafter
    Ideally yes, but the issue here is the Prostar has all sorts of geometry with sharp radii underneath and I'd rather have the bunks suppording a large smooth area than contacting just a few pressure points. The dang trailer has 4 sets of bunks to accommodate. Hopefully choosing the lesser of two evils.
  8. Mastercrafter
    I'd like to buy the X Series, I really like mine. Sending you PM.
  9. Mastercrafter
    Shorestation alum/poly hunks are about $550 with mounts and hardware.
  10. Mastercrafter
    Run them wide. 57 inch gap between bunks in the rear, 44 inches in front. This keeps them off all the geometry on bottom of the hull. I spent way too long perfecting this
  11. Mastercrafter
    If you have or can get a multimeter, I would check voltage at plug to see if it is in fact getting 12v. That would ensure you have power to the seat along with the green light and good breaker. Maybe check the resistance of the driver’s seat element and compare it to observer’s seat. If the values are way off, that could point to a bad heating element in the seat.
  12. Mastercrafter
    Unfortunately I think boats are going to be the least of our country's collective worry in a while here.
  13. Mastercrafter
    Is that little point all the microtuner is?
  14. Mastercrafter
    I’ll be on shore. Looking forward to it. Maybe see ya there @markn.. been a while!
  15. Mastercrafter
    Beautiful. Took some sets behind The Boarding School’s 6.2 last year and it was a winner for sure.
  16. Mastercrafter
    Are you pumping as you’re digging? Or ready to let er fill up? love the wind protection. That’s awesome.
  17. Mastercrafter
    Radar cheapest; Wally best.. and arguable a better value when it comes to useful life.
  18. Mastercrafter
    I goofed and did one acre, not 12. Make that 60K more yards of dirt for a few extra feet depth. Anyways.. pointless rambling.
  19. Mastercrafter
    Few extra feet of depth is just another 5,000 yards of dirt to move.. no biggie 🙄 @Spencer_Shultz is your family doing a DIY dig or paying to have it done? Super cool and looks like a great site.
  20. Mastercrafter
    Remind me what city you’re in?
  21. Mastercrafter
    I love this time of year.
  22. Mastercrafter
    … that 4th tracking fin and rail in the hull drive SO nice though 😎 Driving a neighbor’s boat, I found myself with nothing better to do than peek in the mirror vs driving my 2015 drifter.
  23. Mastercrafter
    While I didn’t have a way to do a side-by-side comparison nor did I use a dB better, I really felt that the Malibu tips I used made the boat sound a lot less aggressive and smoothed out the exhaust note a bit. It’s hard to tell in your video but despite the similar meter reading, do you think it helped the perceived sound at all, or no? What do the MC tips you used have for baffles.. any pics? Curious how they compare.
  24. Mastercrafter
    I used to do a lot of competitive shooting and firearms training, and one of my favorite course names was “you suck, it’s not the gun” I have come to also find that I suck, it’s not the ski.
  25. Mastercrafter
    I've acquired some different neoprene items and these are no longer getting used. 2-4 years old, overall in good condition. The Syndicate Dryflex has two little tears in a knee. Asking 50% of new for each, free shipping. I'm 5'7, 155lbs, 30x30 pants, M shirt size. Despite the Syndicate being XL it fit me best. Camaro Impact Vest is in OK shape but fraying a little bit. It's a little loose on me and floats up a bit. O'Neill Reactor 3/2 Full Wetsuit, M, $75.00 O'Neill Epic 4/3 Full Wetsuit, M-Short, $125.00 O'Neill O'Riginal 2mm Shorty , M, $65.00 Syndicate Dryflex 1.5mm Full Suit, XL, $125 Camaro Impact Vest Pro, Reversible, S, $100
×
×
  • Create New...